Idiomas disponibles
Idiomas disponibles
4.Contact work surface, applying forward p ressure todrive screw
until d epth Iocator contacts t heworksurface. Screwgun will
ratchet automatically,
disengaging
bitfrom screw.
5.Thisdepth sensitive screwgun is suitable f ordriving drywall
screws.
FOR THIS DEPTH SENSITIVE CLUTCH PLEASE REMEMBER:
• The bit will not turn until pressure is applied to the unit. Push to
engage.
• Trigger switch will not depress unless tool is in either forward or
reverse position.
MAINTENANCE
_WARNING:
To reduce
the risk
of injury,
turn
unit off
and disconnect
it from power
source before installing and
removing
accessories,
before
adjusting
or when
making
repairs. An accidental start-up can cause injury.
Cleaning
i_,WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
_ WARNING:
Never use solvents or other harsh chemicals
for
cleaning the non-metallic parts of the tool These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool," never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
i_ WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
NOSECONE MAINTENANCE
(FIG. 1, 5)
If the nose cone (D) becomes hard to turn it may be contaminated
with drywall dust.
1. Remove nose cone from tool.
2. Rinse thoroughly with warm water while rotating both screw
depth adjustment collar (B) and locking collar (C). Never use oil or
solvents.
3. Dry the nosecone completely before reattaching to tool.
Accessories
_WARNING:
Since accessories,
other than those
offered by
DLiWALT, have not been tested with this product,
use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only DEWALT recommended accessories should be used with
this product.
Recommended
accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact DEWALT
Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286,
call 1-800-4-DEWALT (1-800-433-9258)
or visit our website: www.
dewalt.com.
Repairs
The charger and battery pack are not serviceable.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed
by a DEWALT factory service center, a DEWALT
authorized service center or other qualified service personnel. Always
use identical replacement parts.
13
