AquaTru ATU100 Manual Del Propietário página 5

AquaTru 4-Stage Reverse Osmosis System Installation Steps
Installation will be a breeze, since most of the parts are already assembled. We will guide you through
the rest with the following steps:
1. How to use the quick connect fittings
2. Fitting the cold tap water adaptor
3. Mounting the drian saddle for RO waste water
4. Installation of the RO faucet
5. Connecting the TruPure holding tank sanitizer
6. Location and installation of the RO water system
7. Making all of the required water connections
8. System startup
9. System maintenance
It is important that you follow these steps in the order listed above to minimize
any potential installation issues.
Tubing Quick Connect Guide
ST EP
1
The tube connection in your RO system uses a Quick Connect locking mechanism to lock the tubing in place.
Be careful not to damage your tubing when you unpack it. Tubing that is bent at the end or has other damage
will not seal and leak water. If your tubing arrives damaged, please contact customer service for assistance.
Attached Tubing:
Push tubing in straight and level with the Collet.
The tubing will go in 1.5 cm into the
Collet before the lock is activated.
Pull on the tube to make sure the lock has
activated and the tubing is secure.
Release Tubing:
Push and hold the Collet in to release the
lock while pulling out on it.
Collet must be held down while pulling up
on the tube to release the tube.
Under Sink / Instructions
Collet, top loose ring on fitting
Quick connect fitting
Push In
1.5 cm
Push
down on
collet
Collet
Pull up
to lock
Pull up to
remove
tubing
while still
pressing the
collet down
4