Idiomas disponibles
Idiomas disponibles
FAQ & Troubleshooting
PROBLEM
Leaks from filter
Filter not fully installed, or O-ring is damaged
manifold
Water leaks
A gasket is not fully sealing
Two-Year Limited Warranty
Your AquaTru water purifier is warranted to be free from defects in materials and workmanship for two years from the
original purchase date. Should the product have a defect in materials or workmanship, we will repair or replace it without
charge to you (a shipping and processing fee will apply). Warranty does not include filters or storage tank.
To obtain service under warranty, simply call our customer service at +31 (0)24 20 22 195.
This warranty does not cover filters, damage caused by accident, misuse or any use other than as intended and
described in this product manual, or damage resulting from failure to maintain and clean this product as also specified in
this product manual. This warranty applies only to the original purchaser of the AquaTru water purifier.
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES, WHETHER
EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.
Some countries do not allow limitations on the duration of implied warranties, so the above limitation may not apply to
you. While this warranty gives you specific legal rights, you may also have other rights which vary from country to country.
Contact Info for Warranty Service:
AquaTru Water B.V.
Groesbeekseweg 22 6524 DB Nijmegen
The Netherlands [email protected]
17
Under Sink / Maintenance
CAUSE
SOLUTION
Check that the filter is fully installed.
1.
Depressurize the filters by turning off the tap
water supply line and then turning off the RO
holding tank valve."
2.
Turn off the tap water supply line.
3.
Turn off the RO holding tank valve.
4.
Open the RO faucet. When water stops flowing
from the faucet, it is safe to remove each filter.
5.
Inspect O-ring.
6.
Reinstall the filters making sure they are fully
inserted.
7.
Repressurize the system.
Depressurize the system and remove all water from
the tank. Remove the item that is leaking and inspect
the gasket to make sure it is free of any defects. If
the leak is from a thread, apply new plumber's tape
and then reinstall the components, making sure you
tighten in accordance with the manual.
© 2024 AquaTru,
LLC. All Rights Reserved.
®
Aquatruwater.eu
Aquatru.co.uk
