Idiomas disponibles
Idiomas disponibles
RO System Location and Mounting
ST EP
6
Install the three filters into the filter manifold in accordance to the filter color code. Locate the area
under your sink where you want to install the RO system, (RO manifold with filters and RO holding tank).
Note:
The filter manifold can be mounted on a cabinet wall.
Helpful Hint: Write the date of filter installation with a permanent marker on the filter body, or use
our helpful Filter Replacement Records chart on the last page of this manual, so you can easily identify
when to replace the filters.
The Pre-Filter should be replaced every 6 months
The VOC Filter is replaced every 12 months
The RO Filter is replaced every 24 months
The VOC Carbon with PH+ Mineral Boost Filter is replaced every 12 months
Caution
Before mounting the filter manifold on a cabinet wall, make sure it can support the weight of the filters
and manifold and the wall is thick enough to accommodate the mounting screws. If the mounting screws
are too long, we recommend that you buy shorter screws at your local hardware store.
RO System Water Connection
ST EP
7
After you have located the optimal location for your filters and RO holding tank, you will need to cut the
60 mm tubing to the correct length using the diagram below. Cut the tubing using a sharp utility knife.
Make sure not to bend or damage the tubing.
Connection Point:
11
Under Sink / Instructions
A to B
Connect the white tubing from the tap water adaptor valve point A to the
quick connect fitting marked B - marked "Cold Supply" on the filter manifold.
C to D
Connect the white tubing to the quick connect fitting C - marked "Holding Tank"
on the filter manifold, then connect the other end to the holding tank valve D.
E to F
Connect the white tube to the quick connect fitting E - marked "Water Faucet ,"
on the filter manifold, then connect the other end to the RO water faucet quick
connect fitting F.
G to H
Connect the yellow tube to the quick connect fitting marked "Drain" - G
on the filter manifold, then connect the other end to the drain saddle valve H.
