Impact Drilling; Tool Holder, Attachments; Centrotec Tool Chuck [3]; Chuck [4] - Festool PDC 18/4 Manual De Instrucciones

An acoustic signal sounds when the preset torque
is reached and the machine then switches off. You
must release and press the ON/OFF switch [1-4]
again to start the machine.
Drilling
Mark is aligned with drill symbol
torque.
WARNING
Risk of injury
Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defective.
Wear protective gloves.
Prior to initial use: apply multi-purpose grease
to the drill spindle and gearbox neck.

CENTROTEC tool chuck [3]

Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
The machine was designed for impact drilling
into tiles, masonry and stone.
Set the selector switch [1-6] to the hammer symbol.
Set the adjusting wheel [1-8] to the drill symbol.
= maximum

Tool holder, attachments

3
For clamping drill bits and bits with max. shaft di-
ameter of 13 mm.
4

Impact drilling

click
2
1
click
4

Chuck [4]

Clamp tool centrally in the chuck.
2
1
3
3
click
4
5
9