Sliding Out The Appliance; Final Fitting Stage - Gaggenau AF2 Serie Instrucciones De Uso Y Montaje

Sliding out the appliance

Note: Before you remove the appliance, protect the hob
with a piece of polystyrene from the packaging.
1 Use a flat-blade screwdriver to push in the fastening
bolt, and turn it 90° until it locks into place.
2 Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing along
©
with the spring.
Pull gently on the fastening bolt; before you do this,
take hold of the appliance from beneath with the
ª
other hand.
3 Carefully remove the appliance.
32
4 Screw in the filler strip fully.
¨
5 Push in the fastening bolt and turn it 90°.
Note: The fastening pieces on the left and right of
the appliance must be able to move.

Final fitting stage

1 Slide the appliance up into place.
2 Lock the fastening bolts on the left and right.
3 Fit the protective caps on the left and right.
4 Establish the electrical connection.
Note: The extractor hood's housing can be concealed
within the upper cabinet. In doing so, you must observe
the following:
‒ The intermediate floor must not be placed on the
extractor hood's housing.
‒ The front panel must not be secured to the housing.
‒ Access must be available in order to change the
filter and for the after-sales service.
¨
©
ª