Hotpoint Ariston FH 532 IX/HA S Manual De Instrucciones página 25

Grip the door on the two external sides
and close it approximately half way.Pull the
door towards you lifting it out of its seat (see
diagram).
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
! Do not use the oven lamp as/for ambient lighting.
Sliding Rack Kit assembly*
A
A
C B
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: Wattage 25 W,
cap E 14.
3. Replace the glass cover (see
diagram).
To assemble the sliding racks:
1. Loosen the two screws A (see
diagram). If the oven is fitted with self-
cleaning panels, these will have to be
temporarily disassembled.
2. Replace the screws A with the
screws and spacers (B + C) supplied
with the kit.
3. Tighten the new screws B and the
corresponding spacers C, fitting the
self-cleaning panels on again.
D
! Do not place the sliding racks in position 5.
* Only on certain models.
4. Secure the two joints D of the guide
rail in the holes provided on the oven
walls (see diagram). The holes for the
left guide rail are situated at the top,
while the holes for the right one are
at the bottom.
5. Finally, fit the guide rail on the
spacer C.
25
GB