Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Overlay Panel-- Rear View
Create the custom overlay panel using the dimensions shown.
IMPORTANT: The following graphic shows a custom panel for a
door with the hinges installed on the right-hand side. If your
refrigerator has the hinges installed on the left-hand side, rotate
the custom frame 180 ° so the hinge markings will be on the left.
303/ls''
(76.6 crn)
I<
233/4"
(60.3 crn)
A. Drill holes using a '_2" (12 mm) drill bit to a depth of approximately
½" (13 mm) before routing. (4 holes total)
B. Drill holes using a _"
(8 mm) drill bit to a depth of approximately
½" (13 mm) before routing. (4 holes total)
C. Drill holes using a Y_" (2.8 mm) drill bit to a depth of approximately
½" (13 mm) before routing. (12 holes total)
D. Rout shaded areas for hinges to a '_2" (15 mm) depth.
E. Rout shaded areas for hinges to a ¼" (4 mm) depth.
F. Corner radius of _" (3 mm) using a ¼" drill bit when routing
(5 radiuses total)
INSTALLATION
INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
•
Dispose of/recycle all packaging materials.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the refrigerator straight out when moving it. Do not wiggle or
"walk" the refrigerator when trying to move it, as floor
damage could occur.
Clean
Before
Using
After you remove all of the package materials, clean the inside of
your refrigerator before using it. See the cleaning instructions
in
"Refrigerator Care."
important information to know about glass shelves
and
covets:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature
changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size
pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
6
Tabla de contenido
