Dometic CLASSIC RH429LD Instrucciones De Montaje Y De Uso página 12

EN RH429LD, RH429LDAG
No. Description
9 Air sensor
10 Shelves
NOTE For minibars with a door lock, the
manufacturer does not accept liability for loss
or damage of the keys. In this case, a com-
plete door lock can be supplied (see
ic.com/dealer).
Remote control (optional)
Fig.  on page 3
Compo-
No.
nent
1 Red button
2 Black button
Yellow but-
3
ton
4 Blue button
8 Installation
CAUTION! Health hazard
To avoid a hazard due to instability of the
minibar, the minibar must be fixed in accor-
dance with the instructions.
NOTICE! Damage hazard
Do not use extension cords or ungrounded
(two pin) adapters.
The minibar can be built-in if the following conditions
are kept to ensure satisfactory operation and maximum
cooling efficiency.
• The minibar must be leveled carefully to ensure
proper function.
• The socket outlet for the mains connection must
be freely accessible.
• The minibar must not be exposed to radiated heat
(sunlight, radiator, oven).
12
Description
Resets the door control monitor.
Resets the minibar.
Sets inside temperature to 3 °C or
7 °C.
Sets inside temperature to 5 °C or
12 °C.
Reversing the door
NOTE For reversing the door, a different
hinge is needed (see Accessories).
1. Disconnect the mains.
2. Lay down the minibar carefully on its back.
domet
3. Proceed as shown.
Fig. 
Fig. 
4. Ensure that the door closes easily and is sealed
properly.
Changing the decorative plate (free-
standing version only)
Proceed as shown.
Fig. 
Fig. 
Setting up the freestanding version
Fix the feets as shown:
Fig. 
Setting up the built-in version
Ventilation
• Ventilation must be provided as shown in alterna-
tives A, B, C or D.
• Ventilation grills (1), if used, must have openings
of at least 200 cm² each.
• The minimum clearance between the minibar's
back and the surrounding structure should be as
follows:
No.
2
3
• The ventilation duct must at least measure
105 mm x the width of the minibar.
• The entire minibar must project into the ventila-
tion duct as shown (see Fig. ).
• The air passing through the ventilation duct must
not be preheated by any source of heat.
• The ventilation duct must be kept free from any
obstacles. Especially portable multi socket outlets
on page 4 Fig. 
on page 4 Fig. 
on page 5 Fig. 
on page 6 Fig. 
on page 7
Fig.  on page 7
Min. distance
20 mm
105 mm
on page 4
on page 5
on page 5
on page 6