Makita 4101RH Manual De Instrucciones página 8

1
2
3
4
003537
CAUTION:
Do not connect the adapter directly to a faucet. If
•
you do so, the vinyl tube may come off the water
pipe during operation.
Installing cover (A)
1
2
003543
Install the cover (A) on the tool so that its side with
"Upside " mark faces upward.
OPERATION
003545
Adjust the amount of water flow. Hold the tool firmly. Set
the base plate on the workpiece to be cut without the
wheel making any contact. Then turn the tool on and
wait until the wheel attains full speed. Now simply move
the tool forward over the workpiece surface, keeping it
flat and advancing smoothly until the cutting is
completed. Keep your cutting line straight and your
speed of advance uniform.
1. Faucet
2. Pressure
regulator
assembly
3. Water cock
4. Water pipe
1. Clamp
2. Cover (A)
8
CAUTION:
This tool should only be used on horizontal
•
surfaces.
Be sure to move the tool forward in a straight line
•
and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor
and dangerous kickback of the tool.
Since excessive cutting may cause overload of the
•
motor, the depth of cut should not be more than 20
mm (13/16") at a pass. When you wish to cut more
than 20 mm (13/16") deep, make a couple of
passes with progressively deeper settings.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Dressing diamond wheel
If the cutting action of the diamond wheel begins to
diminish, use an old discarded coarse grit bench grinder
wheel or concrete block to dress the diamond wheel. To
do this, tightly secure the bench grinder wheel or
concrete block and cut in it.
After use
Blow away dust from the inside of the tool by running the
tool at an idle for a while. Brush off accumulation of dust
on the base. Accumulation of dust in the motor or on the
base may cause a malfunction of the tool.
Cleaning covers
1
2
003543
When accumulation of dust on the cover (A) looks
excessive, loosen the clamp and remove the cover (A).
Wash off accumulation of dust inside the cover (A) and
wipe it. Then install the cover (A) on the tool so that its
side with "Upside " mark faces upward. Push the
cover (A) toward the motor as far as it will go and secure
it by tightening the clamp.
1. Clamp
2. Cover (A)