Idiomas disponibles
Idiomas disponibles
Before you call for service...
Troubleshooting Tips
Possible Causes
What To Do
"Crackling" or
This is the soundof the
• This is normal.
"popping" sound
metol hooting ond cooling
during both the cookingond
cleoningfunctions.
Excessivesmoking
Excessivesoil.
• Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. Wait until LOCKEDgoes off.
Wipe up the excess soil and reset the clean cucle.
Oven too hot.
• Allow the oven to cool below locking temperature.
openafter a clean cycle
Ovennot clean after
Oven controlsnot properlg set. • Seethe Using the self-cleoning oven section.
a clean cycle
Oven wos heovilg soiled.
• Clean up heuvu spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"LOCKED"flashes
The self-cleon cgcle hos been
• Closethe oven door.
in the display
selected but the door is not
closed.
"LOCKED'is on
The oven door is locked
• Touch the CLEAR/OFFpad. Allow the oven to cool.
when you wont
becousethe temperoture
to cook
insidethe oven hos not
dropped below the
lockingtemperoture.
"F--and a number
You hove o function error code. • Disconnect oil power to the oven for
or letter" flash
at least 30 seconds and then reconnect power.
in the disploy
If the function error code repeats, call for service.
"LOCKED"appears
The controls hove
• Seethe Control Lock section to unlock.
in the oven disploy
been locked.
Control signals after
You forgot to enter o
• Touch the BAKEpod and desired temperature or
entering cookingtime
boke temperoture or
the SELFCLEANHI/LO pod and desired cleon time.
or start time
cleoningtime.
Display goes blank
A fuse in gout home mog be
• Replacethe fuse or reset the circuit breaker.
blown or the circuit breoker
tripped.
The clock is in the
• Seethe Speciolfeotures of your oven control section.
block-out mode.
Disploy flashes
Power foilure.
• Resetthe clock.
Unable to get the
Oven control pods were
• The BROILHI/LO and BAKE pods must be touched
disploy to show "SF'
not touched properlg,
at the some time and held for 3 seconds.
"Probe" appears
Thisis reminding gou to
• Entera probe temperature.
in the display
enter o probe temperoture
offer plugging in the probe.
3O
