Stiga CS 20 Li B Manual De Instrucciones página 170

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 180
IMPORTANT During the first period of use (or
after replacing the chain) it must be checked more
frequently due to settling of the chain.
6.2 SAFETY CHECKS
Run the following safety checks and check that
the results correspond to those outlined on the
tables.
Always carry out the safety checks before
use.
Always carry out a daily inspection of
the machine before use, after a fall or other
impact to detect any damage or significant
defects.
6.2.1 General safety check
Object
Grip and guards
Screws on the
machine and blade
Cooling air ducts
Guide rod
Chain
Guards
Battery
Machine
Throttle trigger lever,
safety buttom
Test driving
Result
Clean, dry, without
traces of oil and
grease, and fixed
correctly and firmly
to the machine.
Correctly tightened
(not loose)
Not clogged
Properly installed
Sharp, not damaged
or worn, mounted and
tensioned correctly.
Intact, undamaged.
No damage to
the casing, no
liquid leakage
No signs of
damage or wear
The levers must
move freely and
not be forced.
No abnormal
vibrations.
No abnormal sound
6.2.2 Machine operating test
Action
Fit the batteries inside
their housing Activate
the throttle trigger lever.
(Fig. 14 A) (without
pressing the throttle
lock buttom (Fig. 14 B)
Press the throttle lock
button (Fig. 14 B) and
throttle trigger lever
(Fig. 14 A)
Release the throttle
trigger lever (Fig. 14 A)
or press the lock button
(Fig. 14 B).
CHECKING THE
CHAIN BRAKE
1. Start the machine
(par. 6.
3)
2. Grasp the hand
grips firmly with
both hands.
3. Use the throttle
lever to keep the
chain moving, push
the front hand guard
forwards using the
back of your left
hand (par. 5.
If any of the results fail to match the
instructions provided in the tables, do not
use the machine! Contact a service centre to
have it checked and repaired if necessary.
6.3 START-UP
t is recommended to use the machine at a
NOTE
I
temperature between -10°C and 60°C
Before each use, make sure that the cap is
NOTE
inserted (fig.16.A.). This prevents dust (sawdust)
going into the charging terminal
Don't start the machine when it's under
charging status.
1. Remove the bar cover guard (Fig. 1.J).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Fit the batteries inside their housing (Fig. 17.
K) pressing down until you hear the "clicks"
firmly into position and assure the electrical
contact;
EN - 10
Result
The throttle trigger
lever remains blocked.
The
levers
move freely and not
be forced. The chain
moves.
The lever automatically
and rapidly returns to
the idle position.
The chain should stop.
3. The chain must stop
moving immediately.
When the chain has
stopped, release the
throttle trigger lever
and disengage the
chain brake (par. 5.3).
3)
.
must
loading