Olympia ECS 615.2 CCD Manual De Instrucciones página 25

11 Troubleshooting
Problem
Device does not
work
Device no longer
functions after a
longer period out
of service or
stops during
operation
Overloading
(material jam)
If you cannot clear the fault yourself, contact your dealer or call the
Note:
Olympia hotline.
Diagnosis & Cause
Is the power plug connected
properly in the power socket?
Is the On/Off switch set to
OFF?
Is the ECS function activated?
Has the device been
assembled properly?
Does the motor fail to start
when material is fed in?
Was the device shutdown for a
longer time? Is the surface of
the device warm? The
permissible operating cycle
has probably been exceeded.
Have you exceeded the
permissible material capacity
(refer to Chapter "Technical
Data")? Has the material been
fed in askew?
Solution
Connect the power plug to the
power socket properly.
Set the On/Off switch to its ON
position.
Press the ECS button so that it
lights up blue.
Ensure that the waste bin has
been inserted properly.
Slide the material in the
respective infeed slot so that it
makes contact with the sensor
in the middle.
First of all, disconnect the
power plug from the power
socket and allow the motor to
cool down to room temperature.
For information on the operating
cycle, refer to Chapter
"Technical Data".
Clear the material jam, refer to
Chapter "Clearing a material
jam".
25