Cleaning the pre-filter
(fig.v)
Filter alert light
status
F0 displays on the
screen
1
Switch off the air purifier and
unplug from the wall outlet.
2
Pull the bottom part of the front
panel to remove it from the
appliance (fig.d).
3
Press the two clips down and pull
the pre-filter towards you (fig.e).
4
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig.w).
5
Air dry the pre-filter.
Note
• To optimize the lifetime of the pre-
filter, make sure it dries completely
after cleaning.
• Wash your hands after handling the
filter.
6
Put the pre-filter back into the
appliance (fig.g).
Note
• Make sure that the side with the two
clips is pointing towards you, and that
all hooks of the pre-filter are properly
attached to the purifier.
10
EN
Follow this
Clean the pre-
filter
7
To reattach the front panel, mount
the panel onto the top of the
appliance first (1). Then, gently push
the panel against the body of the
appliance (2) (fig.h).
8
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time (fig.x).
