Tabla de contenido
Idiomas disponibles
Idiomas disponibles
16.1.9
Setting corner trim
16.1.10 Setting R-scraper
16.1.11 Setting polishing unit
HOLZMANN MASCHINEN GmbH
The polishing unit with the polishing wheels is used to
remove and polish the remaining glue and the edge trims.
The directions of rotation of the polishing wheels are
counterclockwise at the top and clockwise at the bottom.
The polishing wheels should be embedded on the edge of
the workpiece about 3 ~ 5 mm.
This adjustment (vertical displacement) is made by
loosening the clamping screws and the adjustment knobs
on the polishing unit.
www.holzmann-maschinen.at
The two sides are trimmed with a
rather small amount of material.
If it is necessary to adjust the amount
or B, adjust it with the screws ①②.
of material to be trimmed in position A
the screw and nut ③ together.
For the removal at C-position, adjust
nut ③ together with the screw ④.
For the R-corner, adjust the screw and
If the edging tape is changed and a
necessary to adjust the screw ④ and
different thickness is used, it is only
set the counter display to the same
value as the thickness of the edging
tape.
NOTE:
The corner trim is only suitable
under the condition that the thickness
of the edge band is greater than or
equal to 1.5 mm.
The height of the upper and lower units can be
adjusted with the adjusting screw 1 by
loosening the lock nut.
The distance between the steel disc and the
flat scraper should be approximately 1 - 1.5
mm.
OPERATION
45
KAM215all
Tabla de contenido
