Idiomas disponibles
Idiomas disponibles
12.6 Special Safety Instructions for that machine
Work with gloves on rotating parts is not permitted!
•
During operation of the machine wood dust is generated. Therefore, connect the machine
•
to a suitable dust collection system for dust and chips during installation!
Always switch on the dust collection system before you start machining the workpiece!
•
•
Never remove sections or other parts of the workpiece from the cutting area while the
machine is running.
When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
•
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;
•
Excessive noise can cause hearing damage and temporary or permanent hearing loss.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
•
Make sure that the machine is working without vibrations.
Replace cracked and deformed saw blades immediately, they cannot be repaired.
•
Glue and gluing unit are heated during operation, avoid any contact with hot
•
components/glue and wait for cooling phases before maintenance work.
12.7 Hazard Warnings
Despite their intended use, certain residual risks remain. Due to the structure and construction of
the machine, hazardous situations may occur when handling the machines:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death..
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical
suitability/training are and remain the most important safety factor in the error-free operation of
the machine. Safe working depends first and foremost on you!
13
TRANSPORT
Damaged or insufficiently strong hoisting devices and load slings can cause serious
injuries or even death. Always check hoists and load slings for sufficient load capacity
and perfect condition, fasten the loads carefully and never stand under suspended
loads.!
To ensure proper transport, also observe the instructions and information on the transport
packaging regarding centre of gravity, attachment points, weight, means of transport to be used
and the prescribed transport position, etc.
Transport the machine in its packaging to the installation site. To manoeuvre the machine in the
packaging, a pallet truck or forklift with appropriate lifting capacity can be used, for example. For
problem-free unloading, a forklift truck/crane with appropriate lifting equipment and qualified
HOLZMANN MASCHINEN GmbH
DANGER
WARNING
CAUTION
NOTE
WARNING
www.holzmann-maschinen.at
TRANSPORT
38
KAM215all
