Idiomas disponibles
Idiomas disponibles
the end of the workpiece. While the workpiece is running on the conveyor belt, the edge band,
which is glued with sufficient overhang, is sawn off at the front/head end. When the end of
the work piece is reached, the edge band is automatically cut off by the upper edge band saw
at the end. After the process, both saws return to their initial positions.
16.3 Error message and parameter settings
16.3.1
Low temperature alarm
Temperature of glue pot has not yet reached the set temperature. Alarm and troubleshooting can
be viewed in the menu item Parameter setting error message.
16.3.2
Alarm of end-trimming
The purpose of limit switch No. 1 and sensor No. 2 is to protect the crosscut saw unit.
The contact distance from the sensor switch to the trigger should be 1 to 2 mm.
For troubleshooting follow these points:
1. make sure that the optimum pressures are set to the corresponding working cylinders.
2. check the function of sensor no. 2.
3. check the minimum distance of the following plate on the conveyor belt.
4. press the "Reset" button.
16.3.3
Emergency stop alarm
Check that the two emergency stop switches are unlocked and that the door is closed and the
switching contact is established (if necessary, the position of the switch must be adjusted to
establish the closing contact completely).
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
If necessary, the existing overhang (figure
A) or the cutting edge located within the
workpiece (figure B) can be re-adjusted to
the workpiece with the adjusting screw.
Turning clockwise moves the saw blade
towards the workpiece Turning counter-
clockwise moves it away from the
workpiece. Thus a straight edge can be
adjusted.
OPERATION
50
KAM215all
