Idiomas disponibles
Idiomas disponibles
16.1.7
Setting edge band saw angle
16.1.8
Setting double trimming unit
HOLZMANN MASCHINEN GmbH
The two edge band saw units can be swivelled up to
10°. This allows you to choose the shape of the cut-
off, see figure A and B.
To adjust, loosen the screw (3) on the sawing unit,
adjust the angle and then retighten screw (3).
Adjustment can be made at both sawing units (end,
beginning).
www.holzmann-maschinen.at
The trimming unit has two setting options.
The cutters can be adjusted both
horizontally and vertically.
With the adjusting screws C the size of the
radius can be changed (horizontal).
The cutter can be adjusted horizontally with
"+" in front and with "-" back.
Vertically, the tool is adjusted with the A
and B knobs. This should always be done
when replacing the cutters.
NOTE:
When adjusting the vertical position
A and B, the adjustment of the horizontal
position must be the same on both units.
The maximum edge band overhang on the
workpiece should be 2 mm.
OPERATION
44
KAM215all
