Idiomas disponibles
Idiomas disponibles
12. Press the red switch Stop
in order to finish the measurement.
13. Finally, when finishing measurements, turn the equipment off using
the On/Off
switch.
Precaution: Do not connect or disconnect the test leads during the
measurement.
3.5. Display messages
MEGABRAS MPK-204
When turning the equipment on using the On/Off
switch, this
introduction message appears for a while. During that time, the equipment
carries out some functional checkings.
WAIT...
This message appears each time the equipment needs to adjust any
parameter in order to optimize the readings.
PRESS START
The equipment is ready to start a measurement, thus the operator has to
press the Start
button.
START WITH I = 0
It makes the operator remember that to be able to start a test it is
necessary for the Test current control
to be at the zero position (fully
counter-clockwise). Otherwise, Start
will be inhibited.
11
