Idiomas disponibles
Idiomas disponibles
9. Troubleshooting
LED fault display (5.) See section 7.2
Before carrying out any work, remove the
battery pack!
9.1
Fault display (9) active
-Dry-running protection active (see 7.5)
-Pump blocked:
If the motor is blocked (overcurrent), the pump
switches off automatically. Clean the filter (see
section 8) and check the intake area for coarse dirt.
If the problem persists, contact Metabo service.
-Defective or incompatible battery pack:
Replace battery pack. Use only genuine Metabo/
CAS battery packs.
9.2
Device will not start, no LED active
-Power supply interrupted:
Check fit and charge status of the battery pack, if
required replace the battery.
-Battery box not completely closed:
Check protective cover (16) for correct closure and
dirt. The pump only starts via a micro switch in the
box when the protective cover (16) is completely
closed.
-Thermal protection switch in the motor triggered in
motor due to overheating:
Let the pump and battery pack unit cool down, clean
the filter (see 8)
9.3
Pump runs, but does not deliver to too
little
-Intake area dirty:
Clean the filter (see 8) and check the intake area for
coarse dirt.
-Pressure hose dirty or kinked:
Check hose for dirt or kinks, if necessary replace
pressure hose.
-Air in pump or pressure hose:
Start the pump with the pressure outlet open until
the air has escaped. If required, briefly close and
open the regulating/ shut-off valve (22) several
times.
-Low water level
Check water level, completely immerse pump in
water.
10. Maintenance
Remove the battery pack before each
maintenance.
11. Transport
Remove the battery pack for transport and secure
pump against impact.
Secure cable using cable storage (3) on the back of
the pump housing (4)
12. Storage
Remove the battery pack and turn pump upside
down so that any residual water can flow out.
Store the pump and battery pack in a closed, dry
place, protected from frost and out of the reach of
children.
f
13. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
A Chargers: ASC 55, ASC 145, etc.
Order no.: 627044000ASC 55
Order no.: 627378000ASC 145
etc.
B Battery packs:
Order no.: 625026000 2.0 Ah (Li-Power)
Order no.: 625027000 4.0 Ah (Li-Power)
Order no.: 625369000 8.0 Ah (LiHD)
etc.
For a complete range of accessories, see
www.metabo.com or the catalogue.
14. Repairs
Repairs must be carried out by qualified
electricians only!
If you have Metabo devices that require repairs,
please contact your Metabo service centre. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
15. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Battery packs must not be disposed of with regular
waste! Please return faulty or used battery packs to
your Metabo dealer!
Do not throw battery packs into water.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
16. Technical specifications
Explanatory notes on the specifications on page 3.
ENGLISH en
15
