Electrical Connection; General Information; Electrical Data; Connection Diagram - JUMO dicoTEMP 800 Manual De Servicio

5

Electrical connection

5.1

General information

CAUTION!
The electrical connection must only be carried out by qualified personnel.
The temperature of 60° C can be exceeded at the connection terminals.
The choice of cable material, the installation, and the electrical connection of the device must conform
to the requirements of VDE 0100 "Regulations on the Installation of Power Circuits with Nominal Voltag-
es below 1 000 V" or the appropriate local regulations.
The device must be completely disconnected from the mains voltage if there is a risk of contact with live
parts during work on the equipment.
In addition to a faulty installation, incorrectly set values could also impair the orderly function of the down-
stream process or lead to other damage. Access to settings should only be given to qualified personnel.
Please observe the corresponding safety regulations in this context.
5.2

Electrical data

Electrical contact
Contact type
Switching capacity
Switching contact
Switching differential
Switching point accuracy
Switching reliability
DANGER!
Ground the device at the terminal
when connecting the protection conductor.
This cable must have at least the same cross section as that used for the supply line.
Electrical connection
Electrical safety
5.3

Connection diagram

Standard
Single-pole microswitch with mechanically actuated changeover contact
5 (1.5) A
Approx. 1.5% of display range
±0.5% of the display range referring to the switch-off point with rising tempera-
ture
To ensure the maximum possible switching reliability, we recommend a mini-
mum voltage of 24 V and a minimum current of 100 mA.
with the protection conductor. An eyelet or cable lug must be used
Standard: screw terminals, connection cross section up to 2.5 mm
DIN EN 61010-1
Pollution degree: 2
Overvoltage category: II
Electrical connection
Standard:
Screw terminals,
Connection cross section up to 2.5 mm².
5 Electrical connection
Optional
AC 230 V, +10%, cos  = 1 (0.6)
10 (3) A
Must be fused accordingly
1.5 to 3% of display range
Electrical safety
DIN EN 61010-1
Pollution degree: 2
Overvoltage category: II
2
13