Idiomas disponibles
Idiomas disponibles
POWER
Plug unit into a 120-volt AC electrical outlet. Press the power
button to turn unit on.
MIST OUTPUT LEVEL
Mist adjusts from the lowest output
to the highest output
. To increase the mist output, press
the mist output
button. The corresponding mist level will be lit on the display. Each press will increase
by one. Once you reach level 5, it will repeat at level 1.
WARM MIST SETTING
To change the mist temperature from cool to warm mist, press the warm mist
button. "WARM" will
be illuminated on the display and the warm mist
button will illuminate red. To change the mist
temperature from warm to cool mist, press the warm mist
button again to turn warm mist off.
NOTE: Once warm mist is selected, it will take approximately 20 minutes to heat up the mist.
PROGRAMMABLE HUMIDISTAT
The default humidistat setting is CO (continuous on). The programmable humidistat can be set in 5%
increments, from 35% to 55% humidity.
To program the humidity level, press the programmable humidistat
button. The humidity level will
increase/decrease by 5% each time the button is pressed and will be displayed on screen. Press the
humidistat
button repeatedly until the desired setting is reached. The display will show the set
humidity level.
NOTE: To eliminate any programmed humidistat setting, continue to press the programmable humidistat
button until you reach CO, one level above 55%.
NOTE: When the set humidity level is reached, the humidifier will cycle off until the humidity in the room
drops 5% below the set humidity level. The unit will cycle on until the set humidity level is reached again.
NIGHT-LIGHT/DISPLAY LIGHT
Press the night-light/display light
button once to turn on the night-light. The light at the bottom
of the water tanks will turn on, illuminating the tanks. Press the night-light/display light
button a
second time to leave the night-light on, but turn off the display light. Press the night-light/display light
button a third time to turn off the night-light and display light so no lights are illuminated. Press the
night-light/display light
button a fourth time to turn the display light back on.
PROGRAMMABLE AUTO-OFF TIMER
Press the programmable timer
button. Press the programmable timer
button until the desired
timer setting is lit on the display. The programmable timer
will cycle through the following settings:
0 hours, 2 hours, 4 hours, 8 hours, 12 hours. To cancel the timer at any time, press the programmable
timer
button until 0 hours is shown on the display.
7
