Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
No power/no mist from the
mist nozzle
TO CLEAN THE OIL TRAY
Open the oil tray and remove the pad. Essential oil pads should be
changed when switching to a different essential oil scent. If continuing
to use the same scent, set the essential oil pad aside for reuse. Wipe
down the inside of the oil tray with a soft cloth. Place the essential oil
pad back in the tray and close.
NOTE: Leave the essential oil pad out of the oil tray when storing.
TO CLEAN THE SURFACE
Clean the surface of the unit with a soft, damp cloth.
Before storing: Clean the tanks, water reservoir, tank covers, and the
transducer/ultrasonic membrane with a 50/50 mixture of white vinegar
and water. Be sure to rinse and let all parts dry completely before
storing. Clean the oil tray with a soft cloth.
After storing: Rinse the tank, tank covers, water reservoir, ultrasonic
membrane, and essential oil tray with water. Dry completely before
filling. Only fill the tank just before operating.
POSSIBLE CAUSE
• Unit is not plugged in
• Humidifier is not turned
on
• No power at unit
• Low water level
• The humidistat setting
is lower than the current
room humidity
• Transducer/ultrasonic
membrane needs
to be cleaned
12
SOLUTION
• Plug unit in
• Press the power
button to turn
the unit on
• Check circuits and fuses or try a
different outlet
• Refill the tanks with water
• Reset the humidistat to a higher
humidity setting, or change to
continuous on
• Follow Cleaning the Transducer/
Ultrasonic Membrane instructions
in the Cleaning and Care section
