Idiomas disponibles
Idiomas disponibles
E
Troubleshooting
(Continued)
O Radio
Comes)
Station is too far, or signals are too weak.
Select other stations of higher signal level.
The motor antenna relay control lead is not connected correctly.
{f there is a motor antenna in the car, connect the motor antenna
Much noise in FM stereo
and
monaural
broad-
relay control lead to the motor antenna lead that is installed in the
car correctly.
casts.
The radio antenna is not extended enough.
=Fully extend the radio antenna.
Preset station is reset.
Battery cable is not correctly connected.
|
Connect the battery cable to the terminal that is always active.
O CD
(sis
T T
TO)
Disc is upside down.
Place disc in the correct direction with the label side up.
e Disc is dirty.
e Disc has scratches.
Clean disc, referring to the section on "Notes on CD/CD Media (CD-
R, CD-RW)".
Disc is in the CD com-
partment but no sound is
made, or disc is ejected
automatically.
A disc that has data other than CD-DA type is loaded.
=Discs that have CD-DA type data should be used.
The unit may not be successfully play back a CD-R/RW that was
made by the combination of writing software, a CD recorder (CD-R/
RW drive) and a disc if they are incompatible one another. Refer to
instructions for the concerned devices for details.
e Disc is dirty.
e Disc has scratches.
Clean disc, referring to the section on "Notes on CD/CD Media (CD-
Sound skips, bad sound
R, CD-RW)".
quality. (e.g. caused by
noise)
The unit may not be successfully play back a CD-R/RW that was
made by the combination of writing software, a CD recorder (CD-R/
RW drive) and a disc if they are incompatible one another. Refer to
instructions for the concerned devices for details.
