Idiomas disponibles
Idiomas disponibles
GB
MT
Function
Drilling/Screwing
(Percussion OFF)
Hammer drilling
(Percussion ON)
• On/Off switch (6)
• Switching on: Press
• Control the speed progressively: The
further you press the on/off switch,
the higher the speed.
• Switching off: Release
Select tool
Notes
• For hammer drilling, you need a drill
with SDS-Plus attachment (18).
NOTICE! Risk of damage! The operat-
ing mode "Hammer drilling" may only
be used if the keyless chuck is not fit-
ted!
• For drilling without impact in wood,
metal and plastic, use the keyless chuck
with SDS-Plus adapter (15).
• For screwing, use the bit extension
(19)/screw bits (20), which you insert
via the keyless chuck with SDS-Plus ad-
apter (15).
Attaching and removing the
attachment tool
Notes
• Tool holder (1): SDS-Plus
NOTICE! Risk of damage! Only use the
keyless chuck (15) for the operating
mode "Drilling/Screwing".
• The SDS-Plus insert tool/keyless chuck
has some radial play due to the system.
This has no effect on the accuracy of
the hole.
• Before working, clean the attachment
tool with SDS holder and grease the in-
sertion end slightly with the grease (21)
32
Symbol
included in the scope of delivery (0.5–
1 g).
• Ensure the dust cap (2) is not damaged
when inserting tools. The dust cap (2)
largely prevents drilling dust from enter-
ing the tool holder during operation.
NOTICE! A damaged dust cap (2)
must be replaced immediately. It is re-
commended to have this done by a ser-
vice centre.
• Directional data viewed from behind.
Attaching the attachment tool
(SDS-Plus) (Fig. B)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
2. Insert the insert tool into the SDS-Plus
tool holder (1) by turning it.
3. Clamp the attachment tool: Release the
locking sleeve (3).
4. Check that the attachment tool is firmly
secure by pulling on it.
Removing the attachment tool
(SDS-Plus) (Fig. B)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
CAUTION! Risk of burn injury!
2.
Attachment tools – especially drills –
can become very hot. Wear protective
gloves whenever appropriate.
Remove the attachment tool.
Fitting the keyless chuck (Fig. C)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
2. Insert the keyless chuck (15) into the
SDS-Plus tool holder (1) by turning it.
3. Check that the keyless chuck (15) is se-
curely locked by pulling on it.
Inserting hexagonal shank/round
shank attachment tools (Fig. D)
Notes
• Chuck capacity: 0.8–10 mm
