Preparation; Routing Cables - Pioneer PDP-5050SX Manual De Instrucciones

06

Preparation

Routing cables

Speed clamps and bead bands are supplied for bunching cables. Once properly bunched, follow the steps below to route the
cables.
When the speakers are installed on the sides
Attaching speed clamps to the main unit
Attach the speed clamps using any of the 5 holes you prefer
marked with below, depending on your routing system.
14
En
06-PDP5050SX-Eng (14-19)
Speaker cable Bead band
14
(rear view)
Speed clamps
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the Plasma
Display and snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90°, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
2
1
Bunching and securing cables with the bead bands.
Do not allow excessive stress to be placed on the ends of
cables.
05.2.25, 0:14 PM
Speaker cable