Hi Temp Wash
Select this option to increase the water temperature
during the
wash portions of the cycle. Hi Temp Wash raises the water
temperature
to 145°F (63°C), in the main wash. Heating the water
helps improve washing results. Hi Temp Wash is useful when
loads contain baked-on food.
This option may add heat and wash time to the cycle.
NOTE: Hi Temp Wash is an option with the SMART WASH
TM,
Pots Pans, and Normal Wash cycles.
Sani Rinse
Select this option to raise the water temperature
in the final rinse
to approximately
155°F (68°C). Sani Rinse adds heat and time to
the cycle. This high temperature
rinse sanitizes your dishes and
glassware in accordance
with NSF/ANSI Standard 184 for
Residential Dishwashers. Certified residential dishwashers
are
not intended for licensed food establishments.
NOTE: Sani Rinse is an option with SMART WASH
TM,
Pots Pans,
and Normal Wash cycles. Only these sanitization cycles have
been designed to meet the NSF/ANSl requirements.
Heated Dry
The Heated Dry option in combination
with rinse aid will give you
excellent drying results. The energy to use Heated Dry costs
pennies per cycle. Heated Dry is on when the light is lit on the
Heated Dry button. Be sure to load plastic items in the upper rack
to avoid damage.
You may turn off the Heated Dry option by pressing HEATED DRY
so that the light goes off. However, you will have items in your
dishload that will not be dry at the end of the cycle.
NOTE: The Heated Dry option is used in all cycles except Quick
Rinse.
Lock On
Use the Lock On to prevent unintended
use of the dishwasher.
You can also use the lock feature to prevent unintended cycle or
option changes during a cycle.
When LOCK ON is lit, all buttons are disabled.
NOTE: The dishwasher
door can be opened while the controls
are locked.
To turn on the Lock
Press and hold AIR DRY for 4 seconds. LOCK ON glows.
If you press any pad while your dishwasher is locked, the light
flashes 3 times.
To turn off the Lock
Press and hold AIR DRY for 4 seconds. The light turns off.
Delay Hours/4 Hour Delay
Select this option to run your dishwasher
at a later time or during
off-peak hours. You can add items to the load anytime during the
delay. After adding items, firmly close the door until it latches.
The delay will not continue if the door is not latched.
To delay the start
1. Press the delay button to choose the number of hours
delayed.
2. Select a wash cycle and options.
3. Press START.
The dishwasher starts the cycle in the selected number of hours.
NOTES:
•
To cancel the delay and cycle, press CANCEL.
•
To cancel the delay and start the cycle, press START.
Follow the progress of your dishwasher with the Cycle Status
indicators.
O
Q
•
WASHING
DRYING
CLEAN
NOTE: The features on your dishwasher may vary from those
shown here.
Sanitized
If you select the Sani Rinse option, Sanitized glows when the
Sani Rinse cycle is finished. If your dishwasher
did not properly
sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle is interrupted or the incoming water
temperature
is too low. The light turns off when you press any
button or close the door.
Clean
Clean glows when a cycle is finished. The light turns off when you
press any button or close the door.
(On top control models)
The active vent reduces the sounds from your dishwasher. The
vent closes, after the cycle starts, to lock in sound. After the
cycle finishes and the dishes cool for several hours, the vent
opens. This prevents any water vapor from collecting on the
countertop.
Between cycles, the vent stays open for airflow,
reducing the buildup of odors.
NOTE: There is a slight noise when the vent closes or opens. This
is normal.
(On split control models)
The active vent reduces the sounds from your dishwasher. The
vent closes, after the cycle starts, to lock in sound. The Active
Vent opens when wash action ends and vapor is vented into
room. Between cycles, the vent stays open for airflow, reducing
the buildup of odors.
I1
%
•
I
•
%
•
_1"1
;!
Z
NOTE: There is a slight noise when the cover closes or opens.
This is normal.
IMPORTANT: The vapor is hot. Do not touch the vent
during drying.
16