Enable the Liquid Level Sensors
Enable the Liquid Level Sensors
Prepare the System
When the liquid level sensor hub has been connected to the
system (see page 5), its functionality has to be enabled in
the system settings (see Figure 17).
Note: Only users with system owner privilege can change the
system settings.
1. Turn on the system using the power switch located on the
left side of the system.
2. Press Menu and then System Settings.
3. Enable Solvent Monitoring and/or Waste Monitoring.
4. Enable the Biotage
®
5. An information dialog opens, showing the sensor setup
(see Figure 17). Confirm that the setup is according to your
expectations. Otherwise, check the connections at the hub
on the right side of the system (see Figure 13 and Table 1 on
page 7).
Note: The sensor setup has to be confirmed each time
a sensor is connected or disconnected to/from the hub.
You can also at anytime see the sensor setup in the About
view; see Figure 27 on page 12.
Figure 17. The System Settings view when the Biotage
Sensor option has been enabled. An information dialog opens, showing
which sensors that are connected to the system.
8
Liquid Level Sensor option.
Liquid Level
®
Biotage
Liquid Level Sensor for Biotage
®
Selekt Family – User Manual | © Biotage 2023
®
