Idiomas disponibles
Idiomas disponibles
Marking
You can mark the position of the laser beam at the centre
mark (9) on the left and right of the laser receiver when the
beam hits the centre of the reception area (1).
When marking, take care to align the laser receiver so that it
is exactly vertical (with a horizontal laser beam) or horizontal
(with a vertical laser beam), as otherwise the marks are off-
set with respect to the laser beam.
Attaching using the holder (see figure E)
You can use the holder (23) to attach the laser receiver to a
measuring rod (25) (accessory) as well as to other auxiliary
tools with a width of up to 65 mm.
Screw the holder (23) to the mount (11) on the rear side of
the laser receiver with the fastening screw (26).
Rectifying errors
Text display (e)
Problem
PNK
Failed to establish Bluetooth® connec-
tion to the GRL 600 CHV or
GRL 650 CHVG rotary laser
ERR
Calibration of the GRL 600 CHV or
GRL 650 CHVG rotary laser failed
CenterFind mode or CenterLock mode
failed
LR 65 G:
ERR and CL in alterna-
CenterFind mode cannot be started be-
tion
cause the rotary laser is already working
in CenterLock mode.
ERR and CF in alterna-
CenterLock mode cannot be started
tion
because the rotary laser is already
working in CenterFind mode.
Assignment of Functions
Function possible with LR 60 and
Battery charge indicator of the rotary laser
Direction indicators for the position of the laser beam
Relative height indicator
CenterFind mode
CenterLock mode
Function possible with LR 65 G and
Battery charge indicator of the rotary laser
Direction indicators for the position of the laser beam
Relative height indicator
CenterFind mode
CenterLock mode
Bosch Power Tools
Loosen the rotary knob (24) on the holder, slide the holder
onto the measuring rod (25) and retighten the rotary
knob (24).
You can use the spirit level (21) to ensure that the
holder (23) is horizontally aligned along with the laser re-
ceiver. If the laser receiver is mounted at an angle, it will give
incorrect measurements.
The centre line reference (22) on the holder is situated at
the same height as the centre marking (9) and can be used
for marking the laser beam.
Attaching using a magnet (see figure F)
If an attachment is not required to be especially secure, the
laser receiver can be attached to steel parts using the
magnets (10).
Corrective measures
Briefly press the on/off button on the rotary laser to close
the error message. Restart the process for establishing
the connection.
If it is not possible to establish a connection, please con-
tact a Bosch customer service agent.
Read and observe the operating instructions for the
GRL 600 CHV or GRL 650 CHVG.
Press any button to close the error message. Check the
position of the rotary laser and laser receiver before re-
starting the function.
Select CenterFind mode on both laser receivers and re-
start the function.
Select CenterLock mode on both laser receivers and re-
start the function.
GRL 600 CHV
Rotary laser with red laser beam
●
●
●
●
–
GRL 650 CHVG Rotary laser with green laser beam
●
●
●
●
●
English | 21
(600−800 nm)
–
●
●
–
–
(500−570 nm)
–
●
●
–
–
1 609 92A 7M6 | (12.05.2022)
