Idiomas disponibles
Idiomas disponibles
EN
l
It is possible to simultaneously install the "Ventilated
air ducting kit" on one output and the "Front duct-
ing kit" on the other outlet; in this case we suggest
closing the hole not used for front ventilation with
aluminium tape.
Hot air ducting
l
If hot air is ducted in rooms other than those where
the fireplace is installed, it is necessary to mount
aeration vents in the walls or leave slits under the
doors to ensure air circulates between the rooms.
The diameter of the ducting pipes must be equal to
■
or greater than the diameter used for the fan in or-
der to prevent bothersome noises due to the high air
speed.
To prevent excessive head losses and possible air
■
turbulences, it is important that the path of the pipe
is as straight as possible.
Each ducting pipe can have a maximum length of
■
6÷7 m. The length decreases by 1,2 m with every
bend and with every nozzle due to head losses.
18
6.8
DOOR OPENING REVERSAL
To reverse the door's opening direction, proceed as follows:
- Remove the covering completely; consult
- open the appliance's door, see paragraph
- loosen the screws and remove the handle (1)
- loosen the two screws (2) and remove the door (3)
- remove the two side plates (4) and the door closing hook (5)
1
3
x2
Fig. 20
- invert the position of the handle (1), of the side plates (4) and of the
door closing hook (5)
- invert the opening of the door (3), fasten it with the screws (2) and
check that it closes/opens perfectly.
5
"Covering
"Opening the
4
x2
4
2
4
x2
4
2
CS.VES.IST-1_EN_Rev. 0.0_09-23
INSTALLATION
removal"
door"
5
Fig. 21
1
3
x2
Fig. 22
