Idiomas disponibles
Idiomas disponibles
INSTALLATION
Wall mounting (STARBOX UP models only)
To attach the stove to the wall, proceed as follows:
- Remove the covering completely; consult
- remove the combustion chamber entirely – see paragraphs
moving the fume
adapter" and
ber"
- After choosing the product's final position, drill the wall in points (1)
and (2); see the product's technical sheet for the dimensions
- use fixing systems suited to the material with which the wall is
made; screws and wall plugs are supplied but must be sized by the
installer
- attach the support (3) then level it using the two side slots (2)
- fasten the anchoring brackets (4) to the support and to the wall.
1
4
3
- insert the combustion chamber in the outer shell and fasten it; see
paragraphs
"Removing the fume
- insert the fume adapter; see paragraph
er",
- mount the outer shell, consult
crown, connect the flue.
CS.VES.IST-1_EN_Rev. 0.0_09-23
"Covering
removal"
"Extracting the combustion cham-
2
1
2
Fig. 10
adapter"
"Removing the fume adapt-
"Covering
removal"; insert the fume
6.5
CONNECTING THE COMBUSTION AIR
The appliance is standard-configured for drawing combustion air
from the same room where the product is installed, with the non-duct-
"Re-
ed intake situated on the front side.
1
a
We recommend carefully reading the chapter
bustion air
lation properly matches the type of combustion air
intake system of the appliance.
Ducted combustion air intake
l
To modify the configuration of the combustion air in-
take from room to ducted, an appropriate kit must be
used, to be purchased separately.
Proceed as follows:
- remove the pre-cut closing plug (1)
- mount the nozzle (2) and fasten it with the screws supplied with
the kit
intake" to verify that the room of instal-
EN
Fig. 11
"Com-
1
2
Fig. 12
15
