Idiomas disponibles
Idiomas disponibles
Options – Armrest
Standard sideguard, flip-up,
removable with short or long
arm pads (7.81.3)
With the sideguard which is
stepped down at the front it is
possible to move up closer to a
table. To flip them up press the
lever (1) forwards, so that the side-
guard is released.
ATTENTION!
Sideguards, and the armrests
are not designed to be used to
lift or carry the wheelchair.
Sideguard, flip-up, removable
with short or long arm pads,
height-adjustable
The arm pad can be height-adjust-
ed in the following way. Push the
lever (1) and adjust the arm pad (2)
to the desired height. Release the
lever and push the arm pad (2)
down until you hear it click into
place.
ATTENTION!
Sideguards, and the armrests
are not designed to be used to lift or carry the
wheelchair.
Options – Lap belt instructions
Note:
Lap belts are fitted as positional
aids, and are not suitable as trans-
portation restraints.
Step 1
Positioning belt kit. The Positioning
belt kit contains, one positioning
belt, three tri glide buckles and two
cable ties.
Step 2
To assemble the positioning belt.
Take the positioning belt strap and
thread through the tri-glide. Repeat
on both ends of positioning belt.
Step 3
To fit the positioning belt to the
chair. Take the positioning belt
strap and wrap around back post.
Step 4
Thread the positioning belt back
through the tri-glide to form a loop
around the back post. Thread
positioning strap through tri-glide
as shown in step 5.
8
BREEZY ELEGANCE · Rev.A
1
411
2
1
411.2
Step 1
Step 2
Step 3
Step 4
Step 5
To secure the positioning belt to
the chair. Take one of the cable ties
supplied and thread through the
positioning belt strap. Then wrap
around the frame and fasten
together. DO NOT over tighten
positioning belt. Repeat steps 3-5
with both ends of positioning belt.
Step 6
To adjust the positioning belt
use the tri-glide buckles and the
fastening buckle.
Step 7
The positioning belt should be
adjusted so the fastening buckle
is situated in the middle of the
pelvis.
Step 8
The positioning belt should be
adjusted so a hand can be placed
between the user and the belt.
The positioning belt can be used on the Quickie RXS, Quickie 2,
Breezy SLTL and Quickie 2 Millennium wheelchairs.
Advice to client
The positioning belt must only be fitted by an approved Sunrise
Medical dealer / agent. The positioning belt should only be adju-
sted by a professional, or a Sunrise Medical approved dealer /
agent.
The positioning belt must be checked on a daily basis to ensure
they are adjusted correctly (see step 7) and are free from any
obstruction or adverse wear.
Sunrise Medical does not encourage the transportation of any per-
son in a vehicle using this positioning belt as a method of restraint.
Please see Sunrise Medical transit booklet for further advice on
transportation.
Maintenance:
Check lap belt, and securing components, at regular intervals for
any sign of frays, or damage. Replace if necessary.
NOTE:
The lap belt should be adjusted to suit the end user as
detailed above. Sunrise Medical recommend that the
length and fit of the belt be checked on a regular basis to
reduce the risk of the end user inadvertently re-adjusting
the belt to an excessive length.
Step 5
Step 6
Tri-glides
Fastening buckle
Step 7
Step 8
