Idiomas disponibles
Idiomas disponibles
CONNECT DRAIN HOSE
Proper routing of the drain hose avoids damage to your floor
5. Place hose into standpipe (shown in picture) or over side
due to water leakage.
of laundry tub.
Remove drain hose from the washer drum
IMPORTANT: 4.5" (114 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
LE
Drain on
hose form
1. Remove tape from the washer drain port on the back of
the washer.
6. For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts."
2. If clamp is not already in place on elbow end of drain hose,
slide it over end as shown.
tag
3. Squeeze clamp with pliers and slide elbow end of drain
hose onto washer drain port and secure with clamp.
a
as
ws
%.
The floor drain system requires a siphon break that may be
purchased separately. The siphon break (Part Number 285834)
must be a minimum of 28" (710 mm) from the bottom of the
washer. Additional hoses might be needed.
4, The washer drain system can be installed using a floor drain,
wall standpipe, floor standpipe, or laundry tub.
10
