cecotec 2290 TITANIUM Manual De Instrucciones página 23

ENGLISH
- Before using this mode, place it in the spot you wish to clean.
- To activate this mode, press the spiral cleaning button on the app.
Edge mode. Fig. 23
- When this mode is selected, the robot will clean along walls and around furniture (e.g.
table or chair legs).
- Press the edge cleaning button on the app.
Room mode. Fig. 24
- The robot will carry out a 30-minute cleaning cycle when this mode is selected.
- Press the room cleaning button on the app.
- To ensure an efficient cleaning of the room, make sure the robot stays in the room.
Back home mode
Press the Back home button on the robot or on the app (with a house icon) in order to send the
robot to the charging base. The robot vacuum cleaner will continue vacuuming until it reaches
the charging base.
Manual mode
Select the manual cleaning mode on the app to steer your robot vacuum cleaner manually.
Power level function
Select the power level on the app to control the robot suction power during cleaning processes.
There are three suction power levels: Turbo, Normal and Eco.
Cleaning scheduling
To make cleaning easier, the robot has a function that allows it to be programmed daily from
the app. According to the setting, the robot will automatically start cleaning in the selected
days at the desired time.
5. CLEANING AND MAINTENANCE
High-efficiency filter. Fig. 25-26
The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
pollen... It is very important to periodically clean the filter, to avoid these particles from
building up in the filter, causing efficiency loss. It is convenient to carry out this maintenance
once a week.
It is recommended to replace the high-efficiency filter with a new one without exceeding 160
cleaning hours.
44
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot motor and damage it.
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
robot lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the Jaliscazo brush
The Jaliscazo brush is designed for both long and pet hair, as well as carpets, hard floors and
removal of fine and coarse dirt. Its micro-fibre technology captures dust, sand, mites and lint
efficiently in a single pass. This brush is in contact with the floor, and therefore with dirt, so it
can be worn out over time, affecting negatively to the cleaning efficiency.
1. Slightly press the Jaliscazo brush frame tabs in order to open the slot and remove it. Fig.
27
2. Remove any hair, lint or other dirt trapped in the brush and around the shafts.
3. Clear and clean the robot suction channel. Fig. 28
4. Reinstall the Jaliscazo brush and its frame.
Recommendation
It is recommended to clean the Jaliscazo brush once a week with the help of the cleaning brush.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to thoroughly clean edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours or less.
ENGLISH
45