Cleaning And Maintenance - cecotec CONGA 999 VITAL X Manual De Instrucciones

ENGLISH
Cancelling scheduled cleaning
Press the schedule button on the remote control, select the day you wish to delete and change
the set time to 00:00 am., this is the time to be set to cancel the cleaning programme. Fig. 36

4. CLEANING AND MAINTENANCE

Robot filter cleaning
- Remove the filter.
- Carefully shake off all dust from the filter. Fig. 37
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot lower part.
Warning
Do not apply cleaning products directly on the sensors.
Main brush and silicone brush cleaning
1. Slightly press the main brush frame tabs in order to open the main brush slot and remove
it. Fig. 38
2. Remove any hair, lint or other dirt trapped in the brush and around the shafts. Fig. 39
3. Clear and clean the robot suction channel.
4. Reinstall the main brush and its frame. Fig. 40
High-efficiency filter
- The high-efficiency filter is designed with fibres that help trapping dust particles, dust
mites, pollen... It is very important to periodically clean the filter, to avoid these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
- It is suggested to replace the filter by a new one after a maximum of 160 hours or less of
use.
Recommendations
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested
to replace them either after a maximum of 160 hours of use or when they are worn out due to
operation.
38