Idiomas disponibles
Idiomas disponibles
XQB60-91BF
MANUAL
10/22/01
11:42
AH/_ge
26
3. Install the drain
hose to the side of the washer
using drain
hose clamp,
The drain
hose must be placed
into a drainpipe
or sink at least 1 1/2 inches in diameter.
Use the gooseneck
to hold hose in place. To avoid possible water back up, the
drain
hose must reach height of at least 31 1/2 inches minimum
and 40 inches
maximum,
Water Inlet
Water Supply Hose
Goose Neck
Hose Bend
Drain Hose
Note:
"Y Adaptor"
shown in above figure
is only for illustration.
It is not provided
in the box as an accessory.
If you need to utilize this type of hookup,
you can
purchase
a "Y Adaptor"
from your nearest hardware
store,
4. Plug in the Washer
to a regular
115 Volt / 60 Hz, 15 Amps outlet,
Note:
Inspect carefully
for any leaks around
and back of the machine,
If there is a
leak then double check to see if any connections
are loose. You may need to
tighten loose connections,
CAUTION:
If after completing
these steps, you are unsure that unit is properly
installed,
contact
a qualified
installer.
To ensure that your Washer
is
properly
installed
it is recommended
that it be installed by a certified
installer.
25
