Idiomas disponibles
Idiomas disponibles
Installation
Powering the SRXCOOL7KRM
Attach an appropriate receptacle (not included) to the AC power cord's wire terminals. For more information on wire assignment, refer to the
product rear view illustration in the Features section. Make sure to comply with all applicable wiring and safety regulations.
Low Temperature Operation
The SRXCOOL7KRM is a high performance cooler, capable of producing very cold air output. When using the unit in environments that are
already cold (20° C / 68° F or less), Tripp Lite recommends using the Dehumidify Mode only. This will allow the unit to continue to provide the
supplemental cooling while preventing any evaporator icing issues caused by the low room temperature.
Magnetic Door Panel Installation
1
Open the rack enclosure front door.
2A
42U Models: Attach three magnetic door
panels to the inside of the enclosure door.
Leave the front of the SRXCOOL7KRM
exposed to allow adequate airflow into it.
2B
48U Models: Attach five magnetic door
panels to the inside of the enclosure door.
Leave the front of the SRXCOOL7KRM
exposed to allow adequate airflow into it.
Note: Panels may need to be trimmed to fit your
application.
Optional Accessories
Remote Cooling Management
Add remote cooling management to your SRXCOOL7KRM with the optional SRCOOLNET2LX module. It allows you to communicate with and
control the SRXCOOL7KRM as a manageable device on your network and is accessible via Web Browser, Network Management Station or Telnet.
With the SRCOOLNET2LX installed, you can:
• Change settings and monitor temperature and humidity from any location
• Receive alerts via e-mail, SMS or SNMP
• Access detailed condition and event logs
Learn more about the SRCOOLNET2LX at tripplite.com.
2A
6
2B
