Idiomas disponibles
Idiomas disponibles
Operation
Changing Degree Units
The unit can display temperature in both Celsius and Fahrenheit. The default setting for the
SRXCOOL7KRM is Celsius.
To toggle between temperature modes, put the unit in Standby mode. The air conditioner
is in Standby mode when it is plugged into live AC power, but powered off. Then, hold the
"FUNCTION" key for 10 seconds. To verify the degree units have changed, power on the unit.
Alarm
If the internal water tank becomes full, the unit will display the "E4" error code on its screen. To
resume normal function, turn the unit off, remove the drainage plug and drain the excess water
from the unit. Replace the plug and turn the unit on to begin cooling.
One possible cause of the "E4" error is an excessively humid operating environment. If the error
occurs regularly, you should check the humidity level of the operating environment. You may
need to add an external drain.
Maintenance
Periodic maintenance extends the unit's lifespan and permits maximum operating efficiency.
Cleaning the Air Filter
It is important to keep the air filter clean and free of dust. When the filter is dirty or clogged with dust, it decreases cooling efficiency and can
threaten air quality. Tripp Lite recommends cleaning the filter at least once every two weeks.
Before cleaning the filter, turn the unit off and unplug it!
There is a risk of electric shock while the unit is plugged in.
1. Turn the unit off and unplug it.
2. Remove the air filter.
3. Wash the filter with warm water and a neutral detergent. Do not use harsh detergents or
chemicals. Allow the filter to air dry completely after washing.
Note: Do not use water hotter than 40° C (104° F) to clean the filter.
4. Replace the air filter.
5. Plug the unit in and resume normal operation.
Cleaning the Cabinet
Before cleaning the cabinet, turn the unit off and unplug it!
There is a risk of electric shock while the unit is plugged in.
1. Turn the unit off and unplug it.
2. Wipe the unit with a dry, non-abrasive cloth. Do not use gasoline, benzene, thinners or other harsh chemicals that may damage the surface.
Do not pour water directly over the unit or into the working parts. This causes a risk of electrical shock and deterioration of electrical
components and wiring insulation.
3. In extreme cases, wipe the unit with a damp cloth to remove residue.
Moving the SRXCOOL7KRM
1. Turn the unit off and unplug it.
2. Remove the drainage plug and drain any excess water from the unit.
3. Replace the plug.
4. Move the unit to the desired location.
8
