Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.1. - DIVE WITH AIR.
The "Dive" program is automatically turned on by the Archimede
dive computer at a depth of more than 5ft. During a no-decom-
pression dive, the following information is displayed (fig. 9):
1 present depth, in meters (m) or in feet (ft);
2 elapsed dive time, indicated with "DIVE T"
3 maximum depth expressed in meters (m) or in feet (ft)
represented by the "MAX" icon;
4 no-decompression time still available, indicated by "NDL"
(No Decompression Limit);
5 ascent rate indicator in segments;
6 bar graph showing the amount of nitrogen absorbed
during the dive;
7 pixel graph display showing CNS O2 Toxicity
(see chapter. 3.5.);
8 Automatic altitude indicator;
9 Nitrox dive indicator, if available;
10 (
) and (
) icons, or "Info" (button A) and display light (but-
ton B).During the dive, if you keep the A (
you can also get the following important information (fig. 10 ):
1 present PO2;
2 safety factor, if any has been set;
3 current temperature, expressed in °C or °F;
4 the (
) icon if you are taking a dive with air (or the FO2%
percentage in your Nitrox) .
The UFDS display shows (
Related topics:
• 2.3. - Parameter Setting.
• 3.1.2. - Ascent Rate.
• 3.5. - CNS Toxicity Display.
• 3.6. - PO2 Alarms.
3.1.1. - No Decompression Dive.
3.1.2. - Ascent Rate.
The algorithm used in the Archimede Cressi-sub dive com-
puter uses different ascent rates depending on the depth.
The ascent rate is shown on the display by a segmented indi-
cator located on the display bottom right (fig. 9). The indica-
tor works according to the following table:
Depth
0ft
19,7ft
59ft
) button pressed,
If, during the ascent, you exceed the maximum allowed
speed, you will see three full segments on the display, you
will hear an audible alarm and, at the same time, the blinking
(
cator with the ascent rate will also be blinking.
Under these conditions, you must stop your ascent until the
word (
status.
139
).
No segment
1 segment
19.3ft
0.0 ft
-
13.1 ft/min
12.8 f/min
19.3 ft/min
58.7ft
0.0 ft
-
19.7 ft/min
19.3 ft/min
25.9 ft/min
5ft
0.0 m
-
26.2 ft/min
25.9 ft/min
36 ft/min
) icon will be displayed (fig. 11), and the segment indi-
) disappears and the display is back to normal
2 segments
3 segments
-
19.7 ft/min
-
26.2 ft/min
(
)
25.9 ft/min
-
26.2 ft/min
-
39.4 ft/min
(
)
39 ft/min
-
39.4 ft/min
-
52.4 ft/min
(
)
52.1 ft/min
Capítulos
Tabla de contenido
