17 Operating unit:
18 Level indicator
19 Time display
20 Mode button
21 Increase suction strength
22 Reduce suction strength
Warning! Hygiene is of the
utmost priority when handling
breast milk and all parts that
come into contact with it. The
pump should therefore only
be used in a clean and sterile
condition.
Wash your hands thoroughly
before
pump.
The following parts come into contact with
your breast milk and must be cleaned and
sterilised immediately after every use
(see "5.1 Cleaning" on page 20 and
"5.2 Sterilising" on page 21):
1
Silicone breast shields
4
Membrane
5
Connecting element
6
Flow valve
7
Breast milk container/bottle
9
Bottle adapter for NUK First Choice
Bottles (if used)
10 Screw ring
11 Feeding teat
12 Dust cap for teat
13 Sealing disc
The following parts must not be
cleaned and sterilised with water:
14 USB cable
17 Operating unit
5.1 Cleaning
Warning! Milk residues may
damage the material and result
in microbial growth. Thorough
cleaning
necessary.
Caution!
• Clean the flow valve 6 with care so
as not to damage it. We recommend
only rinsing off the flow valve and
boiling it. Cleaning utensils can
cause damage.
5 Cleaning and sterilising
using
the
breast
is
therefore
23 On/off button and
pause/next button
24 Display charging state
25 Display drain mode
26 Display suction mode
27 Display stimulation mode
• Parts should not be put in the dish-
washer as detergents may damage the
materials!
• No moisture should get into the
suction tube 15or the 3-arm tube set
16. If the tube becomes moist, this
may damage the operating unit. If
moisture gets into the tube, it must
be dried before being used again.
1. Dismantle the device as shown in
figure B, proceeding in reverse from
7 to 1.
2. Clean
the
parts with warm water
and a little washing-up
liquid (or NUK Rinsing
Agent).
Then rinse the parts
under running water:
1 Silicone breast shield
4 Membrane
5 Connecting element
6 Flow valve
7 Breast milk container/bottle
9 Bottle adapter for NUK First Choice
Bottles (if used)
10 Screw ring
11 Feeding teat
12 Dust cap for teat
13 Sealing disc
Note:
When
objects, certain foods may discolour
the material (e.g. carrot juice) or
affect its odour (e.g. fennel tea). This
has no effect on the fitness for
purpose or safety of the products.
3. Then
sterilise
"5.2 Sterilising" on page 21).
4. Wipe the suction tube 15, the 3-arm
tube set 16 and the operating unit 17
with a damp cloth.
20
following
rinsed
with
the
parts
other
(see