Dometic EA24B Instrucciones De Montaje Y De Uso página 31

EA24B, EA24D
Fault
The device make
noise.
The door does not
close properly.
The device beeps
consistently.
EN
Possible cause
The noise is probably caused by
the refrigerant. At the end of each
cycle, you will hear noises made
by the flow of refrigerant.
If temperature fluctuations occur,
the contraction and expansion of
the inner walls may cause pop-
ping and cracking noises.
The device is not properly
aligned.
The device is not properly
aligned.
The door hinge was changed
incorrectly.
The door seal is dirty.
The shelves are not fitted cor-
rectly.
The door has been open for more
than 60 seconds.
The door has been open fre-
quently.
The temperature has changed
significantly from the set tempera-
ture.
The device is defect.
Troubleshooting
Remedy
This is a normal process.
➤ Align out the device with the
adjustable feet (see chapter
"Adjusting the feet" on
page 23).
➤ Align out the device with the
adjustable feet (see chapter
"Adjusting the feet" on
page 23).
➤ Check the door hinge and
reassemble correctly.
➤ Clean the door seal.
➤ Check the shelves and refit
correctly (seechapter "Adjust-
ing the shelves" on page 24).
➤ Close the door for at least
15 minutes.
➤ Do not open the door more
often than necessary.
➤ Close the door for at least
15 minutes.
➤ Close the door and wait for
the device to reach the set
temperature.
➤ Let hot food cool down
before placing it into the
device.
➤ Contact an authorized service
agent.
31