Idiomas disponibles
Idiomas disponibles
NOTE
Always check the direction of the rotation before use.
ETC MODE SETTING & DISPLAY
Press the right icon
on the bolts of nuts. (selected one will be lightened on).
There are two ETC modes on, it will be auto shut off on setting of the low and middle
torque. The high torque setting will not be shut off automatically.
Remark : If the red LED bright, it means there is the error or start up protection.
BATTERY POWER INDICATOR
Trigger the tool and Battery Indicator to show the battery pack's remaining capacity
1.
One light ON: 30% remaining capacity.
2.
Two lights ON: 60% remaining capacity.
3.
All lights ON: 100% remaining capacity.
1. After continuous use, allow the impact wrench to sit idle for 15 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
work is started again immediately after the battery has been changed, eventually
resulting in burned-out.
2. Place the point of the bolt in the socket. Keep the tool pointed straight at the bolt.
3. Apply forward pressure to the tool to prevent the socket from slipping off the bolt.
4. To start, turn impact wrench/driver on. Always check torque with a torque wrench.
The fastening torque can be affected by many factors including the following:
1English1
Align Hook to Hole
OPERATION
D
C
E
to select the tightening torque which you would like to apply
English
Fasten with Screw
A
B
-10
