Idiomas disponibles
Idiomas disponibles
The drip tray collects the used water and the coffee grounds collector collects the used
coffee grounds.
The coffee drawer allows you to remove any coffee grounds below the percolation chamber.
If the message "Empty the two trays" is displayed, empty and clean the drip tray.
1. Remove, empty and clean the coffee grounds collector. Fig. 14.
2. Remove and empty the coffee drawer.
Wait for at least 8 seconds, then first put the coffee drawer back in place and then the
coffee grounds collector tray. Fig. 15.
The drip tray is equipped with a float indicating when it requires emptying.
The machine is programmed to ask for the drip tray to be emptied after a certain number
of coffees prepared, irrespective of the number of times you may have emptied the tray
already.
Circuit rinsing
You can perform a rinse at any time by pressing Prog then maintenance. Depending on the
type of recipes prepared, the appliance can perform an automatic rinse when switching off.
It is also possible to set automatic rinsing upon power-up (see "Settings" section page 24).
Automatic clean programs
Automatic clean program for the coffee circuit
The appliance will tell you when a clean program is required. This cleaning must take place
approximatively every 360 preparations.
To perform the clean program, you will need a container with a capacity of at least 20 oz;
this should be placed under the coffee outlets and you will need a KRUPS cleaning tablet.
Follow the instructions displayed on-screen. It is also possible to launch the cleaning via
the maintenance menu.
Important: you do not have to perform the clean program immediately when the
appliance requests it; however, you should do this as soon as possible. If
cleaning is delayed, an alert message
the operation is performed.
The automatic clean program includes two phases: a clean and a rinse cycle; the program
takes about 13 minutes in total.
Important: if you disconnect your appliance during cleaning or in the event of a power
cut, the cleaning program will resume the stage in progress during the
incident. It will not be possible to delay this operation. It is mandatory
due to water circuit rinse reasons. In this case, a new cleaning tablet may
be required. Run the entire cleaning program to eliminate all traces of the
cleaning product that may be harmful to health.
Do not place your hands under the coffee outlets during the cycle.
Cleaning the "one touch cappuccino" accessory
To carry out this cleaning program, you will need two containers (minimum 20 oz) and some
KRUPS cleaning liquid.
Turn the block button clockwise as far as it will go.
You can carry out the cleaning:
– By pressing the "Prog" button
instructions on the screen.
16
"Maintenance"
will remain on the screen until
"Block Cleaning". Follow the
