Idiomas disponibles
Idiomas disponibles
18-21
Fig. 39
Fig. 40:
front WFE connection
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com
Note
The station must not be switched off while the firmware update is
running.
7.4
Connecting auxiliary devices
Please observe the overview diagrams (Fig. 1 and Fig. 2).
Auxiliary devices can be connected either to the port on the front
panel (36) and/or to the port on the back (30) of the WXD 2
desoldering station.
The WXD 2 desoldering station detects automatically which auxiliary
device is connected. The WXD 2 desoldering station shows the
symbol or name of the connected auxiliary device (30/36) on the left
(front port (36), see Fig. 40) or right (rear port).
7.5
Setting the parameters of auxiliary devices
Please observe the overview diagrams (Fig. 1 and Fig. 2).
1. Select the auxiliary device using the auxiliary device key
(front/back) (6, 16).
The variable parameters (e.g. speed) are displayed.
2. Set the required value using the turn-and-click wheel (7).
3. Confirm the value with the Enter key (8)
or
press key 6 to exit.
8 Care and maintenance of the WXD 2
Clean the operator panel, if dirty, using a suitable cleaning cloth.
Seal ports which are not in use with covering caps.
WXD 2
