Idiomas disponibles
Idiomas disponibles
Residual current circuit breaker
n National regulations must be observed
(e.g. IEC 60364‑7‑722 (in Germany DIN
VDE 0100‑722)).
n A differential current sensor for DC resid-
ual current monitoring > 6 mA with trip-
ping characteristics in accordance with
IEC 62752 is integrated in the product for
each charging point.
n Each charging point that is subject to the
provisions of IEC 60364-7-722:2018 must
be protected by a dedicated type B re-
sidual current device.
n Within the scope of HD 60364-7-722:
2016, each charging point must be indi-
vidually protected with at least one type
A residual current device.
n No other circuits may be connected to
the residual current circuit breakers.
Supply line fuse (e.g. miniature circuit breaker,
NH fuse)
n National regulations must be observed
(e.g. IEC 60364‑7‑722 (in Germany DIN
VDE 0100‑722)).
n The fuse for the supply line must be de-
signed for the product, taking account,
among other considerations, of the rating
plate, the required charging power and
the supply line (line length, cable cross-
section, number of outer conductors, se-
lectivity).
n The rated current of the fuse for the sup-
ply line must not exceed 100 A.
16
5.3
Transporting the product
WARNING
Risk of injury due to improper transportation
If the product is not transported correctly, individu-
als may be crushed due to the high weight of the
product. There is a risk of injury when lifting without
means of transport, e.g. to the back.
u Never lift the product without the use of trans-
port equipment.
u Use suitable transport equipment according to
the local conditions and taking into account the
relevant accident prevention regulations.
u Never step under suspended loads.
u Place the product on level ground only.
ATTENTION
Material damage due to improper transportation
Collisions and impacts may damage the product.
u Avoid collisions and impacts.
u Leave the product packed on the pallet and
transport the pallet to the place of installation.
u Remove the device from the pallet shortly be-
fore installation.
u Set the product down on a soft base.
5.4
Opening the product
The tasks described in this section may only
be carried out by a qualified electrician.
WARNING
Risk of injury due to the product tipping over
Even if slightly touched, an unsecured product can
tip over and crush people. In addition, the product
can be damaged.
u Place the product on level ground only.
u Protect the product from tipping over.
u Install the product quickly on a foundation.
