For Your Safety; Target Groups; Intended Use; Improper Use - Mennekes AMEDIO Professional 22 Manual De Instrucciones Y De Instalación

2

For your safety

2.1

Target groups

This document provides information for the quali-
fied electrician and the operator. Knowledge of
electrical engineering is required for certain tasks.
These tasks, which are identified by the "qualified
electrician" symbol, should only be carried out by a
qualified electrician.
1 "1.4 Symbols used" [} 3]
Operators
The operator is responsible for ensuring compli-
ance with the intended use of the product and its
safe operation. This also includes instructing per-
sons who use the product. The operator is respons-
ible for ensuring that tasks that require specialist
knowledge are completed by an accordingly quali-
fied professional.
Qualified electricians
A qualified electrician is a person who, based on his
or her professional education, knowledge and ex-
perience as well as knowledge of relevant provi-
sions, can assess the work assigned to him or her
and identify possible hazards.
2.2

Intended use

The product is intended for use in semi-public and
public areas.
The product is intended exclusively for the charging
of electric and hybrid vehicles, hereinafter referred
to as "vehicle".
n Charging according to Mode 3 pursuant to IEC
61851 for vehicles with non-gassing batteries.
n Plugs and sockets according to IEC 62196.
Vehicles with gassing batteries cannot be charged.
The product is solely intended for stationary, base-
mounted outdoor installation.
4
In some countries, there is a requirement for a
mechanical switching element to disconnect the
charging point from the mains if a load contact on
the product is welded (welding detection). The re-
quirement can be implemented, for example, by
means of a shunt release.
Legal requirements in some countries provide for
additional protection against electric shock. One
possible additional protective measure is the use of
a shutter.
The product may only be operated taking into ac-
count all international and national regulations. Ob-
serve the following international regulations or the
respective national transposition:
n IEC 61851-1
n IEC 62196-1
n IEC 60364-7-722
n IEC 61439-7
When delivered, the product meets the minimum
requirements of the European standards for char-
ging point identification in accordance with
EN 17186. Some countries have additional national
requirements, which must also be observed.
Read, observe and retain this document and all ad-
ditional documents for this product and, if neces-
sary, pass them on to the subsequent operator.
2.3

Improper use

Using the product is safe only when used as inten-
ded. Any other use or changes to the product are
considered improper use and therefore not permit-
ted.
The operator, qualified electrician or user is re-
sponsible for any personal injury or material dam-
age arising from improper use. Mennekes Elektro-
technik GmbH & Co. KG accepts no liability for any
consequences arising from improper use.