Idiomas disponibles
Idiomas disponibles
4. Switch Cover Assembly Only
4.5
Straighten the frayed strands of the switch cover blue and
white wires in preparation to re-install the wire connectors.
Using the two saved wire connectors, attach one
connector to the bare blue wire and one connector to the
bare white wire of the switch cover by twisting the
connector in a clockwise direction until the connector is
fully threaded onto the wire (Figure 18).
These wires must be kept separate.
Gently pull on the connectors to ensure they are firmly
tightened onto the wires and will not fall off.
Check the connectors to ensure no bare wire strands
are visible.
4.6
Locate the switch cover screw (1/8-27 NPS) from the
hardware kit.
Firmly attach the screw into the bottom threaded hole of
the switch cover using a Phillips screwdriver
(Figure 19).
4.7
Using a phillips screwdriver, remove the three pre-installed
#8-32 x 0.3" flat head screws from switch housing plate
(Figure 20).
Retain the three switch housing plate screws for future
installation.
All manuals and user guides at all-guides.com
WIRE CONNECTOR
SWITCH
COVER
Figure 18
Figure 19
Figure 20
12
(Continued)
WIRE CONNECTOR
x 1
SWITCH COVER
SWITCH COVER
SCREW (1)
SWITCH HOUSING PLATE
#8-32 x 0.3" FLAT HEAD
SCREWS (3)
U.L. Model No.: CF135
