Installation - Kenwood DNN991HD Guia De Inicio Rapido

Call using the phonebook
1) Touch [ ].
2) Select the name from the list.
3) Select the number from the list.
4) Touch [ ].
Call using the preset number
1) Touch [Preset #] to start calling the
corresponding phone number.
Call by voice
You can make a voice call using the voice
recognition function of the cell-phone.
1) Touch [ ].
2) Pronounce the name registered in the cell-
phone.
✎
NOTE
• For detailed operation, see Using Hands-Free
Feature (P.122) in the Instruction Manual.

Installation

Ñ Before Installation
Before installation of this unit, please note the
following precautions.
!
WARNINGS
• If you connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground), you
may cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
• Do not cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply
must be connected to the wires via the fuse.
!
CAUTION
• Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal part such as
the heat sink and enclosure become hot.
✎
NOTES
• Mounting and wiring this product requires skills and
experience. For best safety, leave the mounting and
wiring work to professionals.
• Make sure to ground the unit to a negative 12V DC
power supply.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of water
splashing.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
• If the power is not turned ON ("PROTECT" is
displayed), the speaker wire may have a short-
circuit or touched the chassis of the vehicle and
the protection function may have been activated.
Therefore, the speaker wire should be checked.
• If your car's ignition does not have an ACC position,
connect the ignition wires to a power source that
can be turned on and off with the ignition key. If you
connect the ignition wire to a power source with a
constant voltage supply, such as with battery wires,
the battery may be drained.
• If the console has a lid, make sure to install the unit
so that the faceplate will not hit the lid when closing
and opening.
• If the fuse blows, first make sure the wires aren't
touching to cause a short circuit, then replace the
old fuse with one with the same rating.
19
English ñ