Idiomas disponibles
Idiomas disponibles
Connecting to refrigerator:
.
Attach the copper tube to the valve inlet using a
compression
nut and sleeve as shown. Tighten the
compression
nut. Do not overtighten. Use the tube
clamp on the back of the refrigerator to secure the
tubing to the refrigerator as shown. This will help
prevent damage to the tubing when the refrigerator is
pushed back against the wall. Move to step 2.
2. Turn shut-off
valve ON. Check For Leaks. Tighten
any connections (including connections at the valve) or
nuts that leak.
1. Tube Clamp
2. Copper tubing
3. Compression Nut
4. Valve Inlet
so' ne mode@
After the freezer section reaches normal freezer
temperature, the ice maker fills with water and begins
forming ice. Allow 24 hours to produce the first batch of
ice. Ice maker should then produce approximately
7 to 9
batches of ice in a 24 hour-period. Discard the first three
batches of ice produced to avoid impurities that may be
flushed out of the system.
After ice is made, the ice cubes drop into the storage bin.
When ice storage bin is full, ice maker arm raises to the
"OFF" position (arm up). If ice is not needed, you can stop
the ice maker by raising the arm to the "OFF" position (arm
up). Listen for a click sound to be sure that the ice maker
will not continue to operate.
To start ice maker, lower arm to the "ON" position (arm
down). Do not force arm up or down. Do not store anything
on top of the ice maker or in the ice storage bin.
The ON/OFF lever for the ice maker is a wire signal arm
located on the side of the ice maker. Push the arm
down to start making ice automatically, and push it up
to shut off the ice maker.
.
The ice maker is equipped with a built-in water strainer.
If local water conditions require periodic cleaning or a
well is your source of water supply, a second water
strainer should be installed in the Y4-inch water line.
Obtain a water strainer from your nearest appliance
dealer. Install at either tube connection.
4. Plug in refrigerator or reconnect power.
It is normal for the ice cubes to be attached at the
corners. They will break apart easily.
The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as
overnight.
If ice is not being made fast enough and more ice is
needed, turn the Freezer Control toward a higher
(colder) number in half number steps. (For example, if
the control is at 3, move it to between 3 and 4.) Wait 24
hours and, if necessary, gradually turn the Freezer
Control to the highest setting, waiting 24 hours
between each increase.
REMEMBER:
The quality of your ice will be only as good as the
quality of the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be avoided,
make sure the water softener is operating properly and
is well maintained.
