Idiomas disponibles
Idiomas disponibles
Using your Dishwasher..continued
"Refill
Rinse Aid" Indicator
Fill the Rinse Aid dispenser when the Refill Rinse Aid message
comes on as shown in Figure 23.
b) Wait at least ten seconds
or until water
noises
stop before
opening
the dishwasher
door.
c) To resume
the cycle,
shut the dishwasher
door and press
the
On/Off
button.
23
6. Canceling
or Changing
a Cycle
a) To cancel or change a cycle, press and hold for three seconds
the two buttons labeled "Cancel Drain" as shown in Figure 25
until the digital readout shows "0".
4. "Sanitized"
Indicator
The Sanitized indicator appears on the control panel display as
shown in Figure 24.
24
When
the Sanitized
indicator
lights,
it means
that your dishes
have
been sanitized
according
to very strict standards
of wash
time
and water temperature.
The standards
for sanitization
are set
by
the National
Sanitation
Foundation
(NSF) and are explained
in the document
ANSIINSF
184, Residential
Dishwashers.
More
information
on NSF standards
is available
at the NSF website
http://www.nsfconsumer.org/home/appliances.asp.
The dishwasher
cycles
that are NSF certified
are Scrub
Wash,
Normal
Wash,
and China Gentle.
When
these
cycles
are
complete,
the "Sanitized"
indicator
on your dishwasher
control
panel
will illuminate.
Note:
If your household
water
supply
is too hot, your dishwasher's
heating
time may be reduced
and the "Sanitized"
light or symbol
may
not illuminate.
Your dishwasher
Installation
Manual
has
information
on the recommended
temperature
for your
household
hot water
supply.
5.
Interrupting a Cycle
NOTE:
Should
you need to interrupt
a cycle (to add or remove
an
item, to add detergent,
etc.),
it is best to do so within the first 30
minutes
of the cycle.
a)
Press the On/Off
button
to stop the dishwasher.
SCALD
HAZARD:
You could
be seriously
scalded
if you
open
the dishwasher
door
quickly
during
a wash
or rinse
cycle.
Do not fully
open
the dishwasher
door
for at least
10 seconds
after
the dishwasher
has stopped,
or until
water
noises
stop.
b) Wait for approximately
one minute,
then
press the On/Off
button
c) You may now begin a new cycle.
E. Wash Cycle Options
1.
Top Tier Only
TM
Cycle
This option
allows
you to save energy
and water
by washing
loads small
enough
to fill only the top rack.
Note:
The Top Tier Only option
does not reduce
wash
time.
To use the Top Tier Only
cycle
a) Load the top rack.
b) Press the On/Off
button.
c) Press the button
for the desired
wash
cycle.
d) Press the Top Only button.
2.
Delay
Start
This option
allows
you to delay the start of the selected
wash
cycle for up to 24 hours.
a) Press the OnlOff
Button
b) Press and hold for three seconds
the Delay Start button
as
shown
in Figure 26 until the LED display
shows
the number
of
hours
of delay desired.
26
c) Press the button
for the desired
wash
cycle. You can change
the delay time and/or
the cycle at any time during
the delay.
12
Adding
Detergent
and Rinse Aid
Operating
the Dishwasher
